NORAC UC5-BC-FT02A - Manual (Page 25)

22
4. Align the spring target by rotating the metal casing around the linear roll cylinder.
5. Mount the sensor bracket to the damper end (the end with no hoses). A straight edge can
be used to line up the spring target with the center of the hole on the sensor mounting
bracket.
6. Mount the boom target to the cylinder end (the end with hoses).
7. Install the cylinder target (bottom rod) so that it is 5/8” to the side of the spring target
(Figure 21).
8. Install a sensor onto the sensor mounting bracket.
Figure 21: Linear Roll Cylinder Target Alignment
Top View
Side View