NORAC UC5-BC-RG12 - Manual (Page 31)

28
10. Connect each of the two H04 hoses to the corresponding left and right “B” port on the
NORAC valve block. Insert the 6FORXR 6MORT tee (F02) between the hoses and the
valve block.
11. The left raise line (H03) connects to the left tee on the “B” port and the right raise line
(H02) connects to the right tee. Route the hoses to the tilt cylinders. H03 is longer than
H02 since the NORAC valve block is normally located on the right side of the sprayer.
12. Connect H02 and H03 to the cylinders using the 12FORX 6MOR fittings (F05).
13. The existing lower lines do not need to be modified. Leave these lines connected to the
Rogator valve block.
14. Connect hoses H06 to the “A” and “B” ports of the 3 rd station of the NORAC block and
route to the roll cylinder.
15. Connect the hose from the “A” port to the port on the rod end of the cylinder using a
6MOR 6FORX90 (F18) fitting and a 6MB 6MOR (F07) fitting.
16. Connect the hose from the “B” port to the port on the barrel of the cylinder using a 6MOR
6FORX90 (F18) fitting and a 6MB-6MOR (F07) fitting.