NORAC UC5-BC-RG12 - Manual (Page 26)

23
8.3 Linear Roll Cylinder Assembly and Installation
Before continuing, tilt both the left and right booms up to the top of their stroke to
make it easier to rotate the boom.
1. Before installing the linear roll cylinder, the factory springs, dampers and rubber bumpers
must be removed from the sprayer. The springs and dampers to be removed are shown in
Figure 20. The rubber bumper location is shown in Figure 21.
Figure 20: AGCO Factory Spring and Damper
Figure 21: Rubber Bumper Location
Rubber Bumpers to
be Removed (x2)