NORAC UC5-BC-RG11 - Manual (Page 33)

30
11 Software Setup
AGCO armrest version must be 1.0.0.120302.1100 (Update 90).
1. Start up the sprayer and test the sprayer’s functionality. The display terminal does not need
to be powered on for the original boom function switches to operate. Unfold the booms
and raise/lower each boom and the main section.
Confirm that the cabling and hoses are agreeable to the entire range of motion.
2. If any functions do not work, review the hydraulic and electrical portions of this manual to
check for proper installation.
3. Turn on the power for the display terminal using the switch on the side.
4. The procedure for the installation of the UC5 Spray Height Control system is now
complete. Begin the AUTOMATIC SYSTEM SETUP procedure as described in the UC5
Spray Height Control Operator’s Manual.