NORAC UC5-BC-RG11 - Manual (Page 16)

13
6.4 Wing Sensor Installation
1. The sensor bracket should be oriented forward (ahead of the boom).
2. Typically the best mounting location for the outer wing sensor brackets will be near the end
of the boom tips, approximately two feet (60cm) from the end.
3. Mount the inner wing sensor brackets approximately half-way between the chassis and the
outer wing sensors. Insert the spacers (B12) between the sensor bracket and the boom
when mounting the inner wing sensor brackets as shown in Figure 8. This may not be
necessary depending on the boom type.
4. Mount the ultrasonic sensor into the sensor bracket and run the sensor cable through the
sensor tube.
Figure 8: Inner Wing Sensor Bracket with Spacer
Figure 9: Example Mounting of Outer Wing Sensor Bracket