NORAC UC5-BC-JD12 - Manual (Page 36)

33
11.2 JD Tilt Valve Calibration Instructions
1. Warm up the hydraulic oil to at least 60°C. The calibration screen it will show the oil
temperature.
2. Ensure the NORAC system is plugged in and powered up.
3. Test the JD Autofold. Press and hold the foot switch and main up to fold. Press and hold
the foot switch and main down to unfold.
4. On the display, press the Calibration button (Error! Reference source not found.).
Figure 32: Calibration Screen (Tilt Valve Selection)
5. Select the Calibration softkey (A) to view the setup menu.
6. Select the Boom Calibration tab (B).
7. Select Calibration icon (C) next to Tilt Sensor Calibration.
8. Boom Tilt Valve Calibration screen will appear.