beautypg.com

3 hydraulic plumbing – NORAC UC5-BC-JD12 User Manual

Page 31

background image



28

10.3 Hydraulic Plumbing

From this point on in the installation the booms will be inoperative until the

hydraulics are fully installed.

1. After the NORAC valve is mounted, the hydraulic hoses and fittings can be plumbed. The

plumbing for the hydraulic circuit is shown schematically in Figure 3.

2. Install two 6MOR-6FORX90 fittings (F06) onto the “P” and “T” ports of the NORAC valve

block.

3. Connect the hoses (H01) to the 90 degree fittings (F06) on the pressure and tank ports on

the NORAC valve block (V01).

4. Install an 8FORXR-8MORT (F08) tee between the existing tank line and the sprayer valve

block.

5. Install a 6MOR-8FORX (F07) fitting onto the tee (F08). Install a 6MOR-6FORX90 fitting

(F06) onto the F07 fitting.

6. Connect the tank line (H01) from the NORAC valve block to the F06 fitting.

7. Install an 8FORXR-8MORT (F08) tee between the existing pressure line and the sprayer

valve block. The pressure port is located on the smaller valve block next to the main block.

8. Install a 6MOR-8FORX (F07) fitting onto the tee (F08). Install a 6MOR-6FORX90 fitting

(F06) onto the F07 fitting.

9. Connect the pressure line (H01) from the NORAC valve block to the F06 fitting.

10. Insert the 6FORXR-6MORT tees (F05) into the existing raise and lower lines at the wing

cylinders.

11. Install four 6MOR-6FORX90 fittings (F06) onto the 6FORXR-6MORT tees (F05).

12. Install four 6MOR-6FORX90 fittings (F06) onto the “A” and “B” ports of the NORAC valve

block.

13. Connect 4 hoses (H02) between the 90 degree fittings (F06).

14. The “raise” lines must be connected to the "B" ports of the NORAC valve block. The

“lower” lines of the cylinders must be connected to the "A" ports of the NORAC block.

15. Install a 6MOR-6FORX90 fitting (F06) onto the “B” port of the 3

rd

station of the NORAC

valve block.