NORAC UC5-BC-HD08A - Manual (Page 23)

20
5. Mount the sensor bracket to the damper end (the end with no hoses). A straight edge can
be used to line up the spring target with the center of the hole on the sensor mounting
bracket.
6. Mount the boom target to the cylinder end (the end with hoses).
7. Install the cylinder target (bottom rod) so that it is 5/8” to the side of the spring target
(Figure 22).
8. Install a sensor onto the sensor mounting bracket.
Figure 22: Linear Roll Cylinder Target Alignment
Top View
Side View Side View - Installed
Sensor
Mount
Spring
Target
Cylinder
Target