NORAC UC5-BC-HD08A - Manual (Page 17)

14
6.3 Input Module
1. Install the input module (E03) on the boom near the enclosure that houses the HARDI
DAH09 PCB. Secure it to the boom using cable ties or optional brackets.
2. Connect the free end of the CANbus cable (C01) from the control module to the input
module.
3. Connect cable C35 to the 12 pin Deutsch connector of C20. Connect the other end of
C35 to the Thru 2 connector on the side of the input module.
4. Connect the remaining connector on C20 to the Thru 1 connector on the input module.
5. Insert the 12 pin plug (P02) into the OEM 3 connector on the input module.
Figure 14: Input Module Connections
6. Run the DB15 connector and the wires with the spade connectors of C12 to the DAH 09
PCB by passing it through a hole in the enclosure. Seal the hole using the weather-proof
strain relief fitting.
7. Connect the DB15 connector of cable C12 to the DAH09 DB15 connector.
8. Connect the red wire with spade connector on C12 to the Switched 12VCC on the
DAH09 board (Figure 15).
9. Connect the black wire with spade connector on C12 to the GND on the DAH09 board
(Figure 15).