NORAC UC4+BC+FT2A - Manual (Page 20)

16
5
END USER INSTALLATION
1. Install the UC4+ Control Panel
(E01) in the cab of the sprayer.
Mount the panel where it will be
clearly visible and within easy reach
of the operator.
A good spot to mount the UC4+
control panel is on the right hand
side of the cab to the Roll Over
Protection Bar. Four pilot holes for
the screws provided need to be
drilled to facilitate the control panel
mounting.
Another option is to purchase an
adapter for the flexible panel mount
that has a 3/8" NC threaded stud on
the end to bolt through an existing
mount. You can find these at your
local outdoor store as a RAM
mount part number RAM-B-236.
(See
http://www.ram-
mount.com/)
Figure 17: Control Panel Mounting
Figure 18: Cable Configurations: C10 and C11
ROP