beautypg.com

NORAC UC4+BC+FT2A User Manual

Page 15

background image

11

4. Align the spring target by rotating the

metal casing around the linear roll
cylinder.

5. Mount the sensor bracket to the

damper end (the end with no hoses). A
straight edge can be used to line up the
spring target with the center of the hole
on the sensor mounting bracket.

6. Mount the boom target to the cylinder

end (the end with hoses).

7. Install the cylinder target (bottom rod)

so that it is 5/8” to the side of the
spring target (Figure 13).

8. Install a sensor (E02) into the sensor

mounting bracket.


Figure 13: Linear Roll Cylinder Target Alignment

Top View

Side View