beautypg.com

NORAC UC4+BC+WR2 User Manual

Page 13

background image

10

number on the right hand side
(Figure 9).

5. Sensor cables should run through the

mounting bracket tube and then behind the
member the bracket is mounted onto.
Cable-tie the connector in place. The cable
must not be allowed to hang below the
boom (Figure 6).

Figure 6: Another Acceptable Mounting

Avoid mounting sensors in locations

where they may read from parts of
the boom as shown in Figure 7.

Figure 7: Poor Mounting

(Sensor Reading off Boom)

General mounting rules for UC4+
ultrasonic wing sensors:

a)

In its lowest position, the sensor mouth
must be 9 inches or more from the ground.

b)

The bottom of the sensor must be at least 9

inches in front of the spray nozzles.

c)

The bottom of the sensor must be at least 9
inches above the spray nozzles.

d)

Ensure that there are no obstructions within
a 12-inch diameter circle projected directly
below the center of the sensor.

e)

The sensor should be approximately vertical
at normal operating heights.

Figure 8: Sensor Mounting Guidelines

A

B

B

D

C

Ultrasonic
Acoustic Cone