NORAC UC4+BC+WR2 - Manual (Page 10)

7
4
INSTALLATION PROCEDURE
4.1 E
XISTING
S
YSTEM
C
HECK
It is necessary to check the existing system’s
functionality before installing the UC4+ Spray
Height Control system.
1. Drive your sprayer onto a flat piece of land,
with unobstructed boom movement (e.g. no
power lines).
2. Test that all boom functions operate
correctly. As you test each function check it
off in Table 3.
It is necessary to test the boom
functions in all directions
Table 3: Hydraulic System Function
Check Sheet
BOOM
FOLD
IN
FOLD
OUT UP DOWN
LEFT
MAIN
RIGHT
ROLL*
N/A N/A
* Some sprayers may not have this function.
4.2 B OOM S PEED T EST
IMPORTANT:
Raise/lower all boom sections several
times to warm up the hydraulic system.
Grease all moving parts for consistent
results.
1. Lower each boom and main section as close
to the ground as possible.
2. Set your sprayer at field working RPM on
the throttle and mark this value in Table 4.
You will need a stopwatch or a watch
that displays “seconds” for the next
step.
3. Raise the LEFT boom from its extreme
LOW position to the very TOP of its travel.
Record the time this takes in Table 4, “Trial
#1” for “Left UP”.
4. Lower the LEFT boom from its extreme
HIGH position to the BOTTOM of its travel.
Record this time in Table 4, Trial #1 for
“Left DOWN”.
Be careful when lowering the booms
so they don’t hit the ground.
5. Similarly, record two more time trials (Trial
#2 & #3) for the LEFT boom and record in
Table 4.
6. Repeat Steps 1 through 5 for the RIGHT,
MAIN and ROLL functions.
Your sprayer may not have a roll
feature.
7. Average the three trials recorded for each
boom movement and record this calculation
in the “Average Time” slot in Table 4.
8. These “Average Times” now represent how
quickly your system can react to manual
control. In Section 4.8, this procedure is
repeated with the UC4+ Spray Height
Control system installed for comparison and
troubleshooting purposes.