beautypg.com

NORAC UC4+BC+RG7 User Manual

Page 25

background image

22

Figure 25: Cable Configurations: C11, C12 and C03

10. Route C11 to the rear of the sprayer,

in the vicinity of the valve block.

11. Connect the Interface cable (C12) to

the mating connector on C11 (Figure

25).

12. Route the free end of C12 to the

Rogator valve block.

13. Tee the Deutsch connectors into the

connectors on the sprayer solenoids.
To tee in, unplug the existing connector
from the solenoid and insert the
NORAC plug. Connect the Rogator
plug that was disconnected, to the
receptacle end of the tee on the
NORAC cable. The cables to be teed
in are shown in Table 7.

One of the tees marked “MAIN

UP” will not be used.

Table 7: Rogator and NORAC Valve

Labels

Rogator Label

NORAC Label

LH FOLD UP

LEFT UP

LH FOLD DN

LEFT DN

RH FOLD UP

RIGHT UP

RH FOLD DN

RIGHT DN

HOIST UP

MAIN UP

HOIST DN

MAIN DN

14. Connect the 6-pin Tower on the valve

cable (C03) to the mating connector on
C10 (Figure 25).

15. The connectors on the valve cable

(C03) are marked RIGHT UP, LEFT
UP
, RIGHT DOWN and LEFT
DOWN
. Cables labeled with UP go
on the same side as the hydraulic hoses.

This manual is related to the following products: