NORAC UC4+BC+RG7 - Manual (Page 20)

17
4.5.3 Inverted Roll Sensor Mounting
If desired, the Roll sensor may be mounted
inverted, so long as the connector exits
towards the right-hand boom. Inverted mounting may be used to optimize the
mounting criteria explained in Section 4.5.
Figure 17: Inverted Roll Sensor Mounting may be Applicable for Optimal
Performance
4.5.4 Temperature Probe
Fasten the temperature probe (E03) to the
UC4+ valve block using the included
3/8x1/2” bolt as illustrated in Figure 18.
Figure 18: UC4+ Valve Block with
Temperature Probe Installed