beautypg.com

NORAC UC4+BC+RG7 User Manual

Page 24

background image

21

2. Connect the UC4+ power cable (C10)

to the UC4+ Control Panel in the
sprayer cab. Ensure that both plugs are
connected to the receptacles of the
panel (Figure 23).

Ensure the UC4+ control panel’s

power is OFF for the remaining
installation (Bottom of switch
pressed IN). Use caution when
handling the 12 V power line of
the Rogator wiring.

3. Connect the power pigtail interface

cable the mating connector on C10.

4. There is an access hole to the sprayer

electrical panel on the rear right corner
of the cab. Route the free end of C14
to the electrical panel through this hole.

5. In the electrical panel wire the white

wire on C14 to +12V and the black
wire to Ground. Each polarity is labeled
on the wire. Refer to for Figure 24

recommended +12V and Ground
connections inside of the electrical
panel.

6. Install the provided 15A automotive

fuse into the slot beside the +12V
power connection.

Figure 24: Power and Ground Connections

7. Route C10 to the exterior of the cab.

There is an access panel located on the
rear right corner of the cab floor. Use
this panel to route C10 through.

8. Connect the 16-pin AMP plug of the

valve extension cable (C11) to the free
end of C10 on the outside of the cab
(Figure 23).

Connect

GROUND

wire here

Connect +12V wire

(spade terminal)

here and install 15A
fuse

This manual is related to the following products: