NORAC UC4+BC+RG6 - Manual (Page 29)

26
11. Unplug the existing connectors on the
Rogator left and right boom control
valve connections. There are 4
connectors to unplug: LH FOLD UP
(LEFT UP), LH FOLD DN (LEFT
DOWN), RH FOLD UP (RIGHT UP)
and RH FOLD DN (RIGHT DOWN).
12. Plug in the 2-pin Deutsch connectors of
C12 to the matching connectors of
Rogator cable(s). For each connector,
the function (e.g. “LEFT UP”, etc.) is
labeled on the branch wire of C12.
13. Connect the 6-pin Tower on the valve
cable (C03) onto the mating connector
(S6A) on C11.
Alternate cabling is available
from NORAC if the connectors
on C12 do not match your valve
block. Refer to Table 6 on page
8.
Figure 29: Rogator ’64 / ’74 Valve Block Connections