NORAC UC4+BC+RG6 - Manual (Page 28)

25
5. Route the receptacle end (R16) of C10
out of the cab. Use the knockout in
Access Panel 2 to route (Figure 27).
6. Connect the 16-pin AMP plug (P16) of
the valve extension cable (C11) to the
free end (R16) of C10 on the outside
of the cab (Figure 24).
BOTTOM TOP (view from cab)
Figure 27: Cable Routing Through Knockout
Figure 28: Cable Configurations: C11, C12 and C03
7. Route C11 to the rear of the sprayer,
in the vicinity of the valve block.
8. Connect the 6-pin Shroud (S6) on the
Interface cable (C12) to the mating
connector (T6A) on C11 (Figure 28).
9. Route the free end of C12 to the
Rogator valve block.
10. Insert 3 sets of the Deutsch connector
tees (which are labeled as “MAIN UP”,
“MAIN UP” and “MAIN DOWN” on
the branch wires) between the matching
Rogator main control valve connections:
HOIST UP (MAIN UP), HOIST DN
(MAIN DOWN) (Figure 29). (Both
“MAIN UP” tees have the same
functionality and can be matched to the
HOIST UP connection(s)).