NORAC UC4+BC+RG6 - Manual (Page 21)

18
Figure 15: Roll Sensor Mounting with Respect to Sprayer Orientation
4.5.1 Boom Roll Sensor Mounting
The boom roll sensor (E04) must be
mounted to the rotating part of the boom.
Follow these guidelines and refer to Figure
16 to mount the sensor.
1. Make sure you are using the roll sensor
that does NOT have a temperature
probe (only one cable) (E04).
2. The boom roll sensor must be mounted
to the rotating part of the boom
suspension.
3. Use cable-ties to secure the bracket to
a square edge feature (square tube).
4. Ensure the AMP (circular) connector
exits towards the Right Hand Wing
(when looking from the rear of the
sprayer).
5. Securely cable-tie the connector to the
frame.
4.5.2 Chassis Roll Sensor Mounting
The chassis roll sensor must be mounted to
a non-rotating part of the boom. To mount
the chassis roll sensor, follow the following
guidelines and refer to Figure 16.
1. Make sure you are mounting the roll
sensor that does have a temperature
probe (2 cables) (E03).
2. Mount the chassis roll sensor (E03) to a
non-rotating part of the boom.
3. Cable-tie the bracket to a square edge
feature (square tube).
4. The AMP (circular) connector MUST
exit towards the Right Hand Wing
(when looking from the rear).
5. Securely cable-tie the connector to the
frame.
* The boom frame
roll sensor does not
have a temperature
probe