NORAC UC4+BC+OM1 - Manual (Page 19)

16
5
END USER INSTALLATION
5.1 4480BC C ABLE I NSTALLATION
The following instructions refer to the
4480BC cable if it has not been installed
already on your tractor.
1. Connect the power and ground
pigtail from the 4480BC cable. The
power connections must be wired
such that the power is switched
ON/OFF with ignition key.
Figure 15 - Power Cable Connections
2. The handgrip should be installed in
the tractor so that the operator can
easily and comfortably use the
controller. Generally this location is
the right hand side of the seat,
mounted on either the console or the
arm rest, with the grip leaning
forward about 30 degrees and the top
tilted towards the operator about 30
degrees.
3. After the grip is mounted the switch
protector plate on the back of the
grip can be removed. Loosen the
two screws holding the plate to the
grip, remove the plate and reinstall
the screws.
Figure 16 - Hand Grip Installation
4. Route the sprayer cable out of the
cab of the tractor to a convenient
location by the hitch. To maintain
cab pressure, if any access holes
need to be drilled they will have to
be sealed. To accomplish this use
any method approved by the tractor
manufacturer. (i.e. silicone sealant,
foam rubber, etc.)