beautypg.com

1 boom frame roll sensor mounting – NORAC UC4+BC+OM1 User Manual

Page 13

background image

10

4.4.1 Boom Frame Roll Sensor Mounting

1. Use the supplied hardware to mount the

boom frame roll sensor (E04) as shown in
Figure 8.

When mounting the boom frame roll sensor
follow these guidelines:

a) To prevent bending the bracket, ensure

bolts are placed as close together as
possible (minimize C in Figure 8).

b) Be sure to use the roll sensor without the

temperature probe (E04).

c) When the boom is centered (not rolled

over) the roll sensor should be level with
respect to the sprayer chassis.

d) It is best to mount the roll sensor to the

left hand trapeze link (when looking
from the rear of the sprayer).

e) The roll sensor AMP (circular)

connector MUST exit towards the
right had wing
(when looking from the
rear of the sprayer).

Figure 8 – Boom Frame Roll Sensor Mounted

to a Trapeze Link

2. Cable-tie the sensor connector to the

frame with enough slack to allow the
link to rotate.

Make sure the bracket does not

collide with any parts of the
sprayer when the boom rotates.
Also ensure there is enough slack
to allow the roll sensor to rotate.