NORAC UC4+BC+JD8 - Manual (Page 26)

23
4.7 E
LECTRICAL
I
NSTALLATION
1. Install the UC4+ Control Panel (E01) in the
cab of the sprayer. Mount the panel where
it will be clearly visible and within easy reach
of the operator.
A good spot to mount the UC4+ control
panel is on the right hand side of the cab to
the Roll Over Protection Bar. Four pilot
holes for the screws provided need to be
drilled to facilitate the control panel
mounting.
If desired, a mounting bracket (part
#A53255) can be purchased from your local
John Deere dealer to allow the UC4+
control panel to be mounted to the existing
John Deere terminal mount. Another
option is to purchase an adapter for the
flexible panel mount that has a 3/8" NC
threaded stud on the end to bolt through
the existing JD mount. You can find these at
your local outdoor store as a RAM mount
part number RAM-B-236. (See
http://www.ram-mount.com/ )
Figure 28: Control Panel Mounting
Figure 29: JD Control Panel Mounting
ROP