NORAC UC4+BC+FC1 - Manual (Page 25)

22
9. Install the 2-pin connectors from C03
onto each NORAC valve as shown in
Figure 26.
10. The connectors on the valve cable
(C03) are marked RIGHT UP, LEFT
UP, RIGHT DOWN and LEFT
DOWN. Cables labeled with UP go
on the same side as the hydraulic hoses.
Figure 26: Valve Cable Connections
11. Connect the CAN Node cable (C02B)
to the 4-pin AMP plug on C01.
12. Route the CAN Node cable (C02B) to
the roll sensors. Follow existing cables
and/or hydraulic lines.
Figure 27: Cable Configurations: C01,
C02, C02B, C03 and C04
13. Connect the sensor branch cable (C02)
to the 4-pin AMP plug on C02B.
14. Route the sensor branch cable (C02) to
the wing and main sensors. Follow
existing cables and/or hydraulic lines
along the boom.
15. Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the
main section, parallel lift, and
FOLDING boom movement.