NORAC UC4+BC+FC1 - Manual (Page 19)

16
4.5.3 Inverted Roll Sensor Mounting
If desired, the Roll sensor may be mounted
inverted, so long as the connector exits
towards the right-hand boom. Inverted
mounting may be used to optimize the
mounting criteria as explained at the
beginning of Section 4.5
Figure 19: Inverted Roll Sensor Mounting may be Applicable for Optimal
Performance
4.5.4 Temperature Probe
Fasten the temperature probe (E03) to the
UC4 valve block using the included 3/8x1/2”
bolt as illustrated in Figure 20.
Figure 20: UC4+ Valve block with
Temperature Probe Installed