NORAC UC4+BC+AP2 - Manual (Page 24)

21
Figure 24: Cable Configurations: C13, C03 and C04
6. Route C11 to the rear of the sprayer,
in the vicinity of the valve block.
7. Connect the 3-pin shroud (S3) on the
sense cable (C13) to the mating
connector (T3) on C11) (Figure 24).
8. Route the free end of C13 to the
Apache valve block and insert all of the
2-pin tees between the matching
Apache valve connections. For each
tee, the function (e.g. “Left Up”) is
labeled on the branch wire.
9. Connect the 6-pin shroud (S6) on the
main lift valve cable (C12) to the mating
connector (T6A) on C11 (Figure 24).
10. Route the free end of C12 to the
vicinity of the Apache main lift valve and
insert the 2-pin tees between the
matching Apache valve connections.
For each tee the function (e.g. “Main
Up”) is labeled on the branch wire.
11. Connect the 6-pin tower on the valve
cable (C3) onto the mating connector
(S6A) on C11 (Figure 24).
12. Route the free end of C03 to the
vicinity of the NORAC valve block.
13. The connectors on the valve cable
(C03) are marked RIGHT UP, LEFT
UP, RIGHT DOWN and LEFT
DOWN. Cables labeled with UP go
on the same side as the hydraulic hoses
on the 44963D block.
Figure 25: Valve Cable Connections
14. Connect the CAN Node cable (C02B)
to the 4-pin AMP plug on the tee of
C05 (Figure 26).
15. Connect the AMP 4-pin plug – P4 (C11)
to the 4-pin AMP receptacle on the tee
of C05 (Figure 26).