NORAC UC4+BC+AP2 - Manual (Page 17)

14
4.5.1 Boom Frame Roll Sensor
Mounting
1. Use the supplied hardware to mount
the boom frame roll sensor (E04) as
shown in Figure 15.
When mounting the boom frame roll
sensor follow these guidelines:
a) To prevent bending the bracket,
ensure bolts are placed as close
together as possible (minimize C in
Figure 15).
b) Be sure to use the roll sensor
without the temperature probe
(E04).
c) When the boom is centered (not
rolled over) the roll sensor should
be level with respect to the sprayer
chassis.
d) It is best to mount the roll sensor to
the left hand trapeze link (when
looking from the rear of the
sprayer).
e) The roll sensor AMP (circular)
connector MUST exit towards
the right hand wing (when
looking from the rear of the
sprayer).
Figure 15: Boom Frame Roll Sensor
Mounted to a Trapeze Link
2. Cable-tie the sensor connector to the
frame with enough slack to allow the
link to rotate.
Make sure the bracket does not
collide with any parts of the
sprayer when the boom rotates.
Also ensure there is enough slack
to allow the roll sensor to rotate.