beautypg.com

NORAC UC4+BC+AP2 User Manual

Page 23

background image

20

Figure 23: Cable Configurations: C10 and C11

2. Connect the UC4+ power cable (C10)

to the UC4+ control panel in the
sprayer cab. Ensure both plugs (P16
and P4) are connected to the panel
Figure 23.

Ensure the UC4+ Panel’s power

is OFF for the remaining
installation (Bottom of switch
pressed IN).

3. Connect the 3-pin AMP plug (P3) on

C10 to the 3-pin AMP receptacle (R3)
on the power pigtail interface cable
(C14). Connect the pigtails on C14 to
a 12V power connection. Cable C14
may not be needed if there is an
auxiliary power connector to connect
the 3-pin AMP plug (P3) of C10 to.

4. Route the receptacle end (R16) of C10

out of the cab.

5. Connect the 16-pin AMP plug (P16) of

the valve extension cable (C11) to R16
of C10 (Figure 23).