Card installation – Mytek Digital FW DIO Card (ver. 1.2 / Nov 2010) User Manual
Page 6
Mytek FW DIO Card – User Manual
4. Configuration
On first power up of the converters, each converter should
be recognized by the computer and have the driver
installed automatically. Further configuration of inputs and
outputs is done in your DAW software.
In the Mytek Firewire Control Panel (Mac: in System
Preferences) check if the desired sampling frequency is
displayed and if the ADDA 8x192 converter is set as the
clock source. If more than one converter is attached, each
one will have unique name.
Card Installation
The DIO-FW card can be installed in either the DIOCARD1 or
DIOCARD2 slot. The card can be installed together with any
other card available for the 8x192 converter. If Protools DIO
card is installed it will work in slot 1 only. All other DIO cards
including Firewire will work in either slot.
8x192 ADDA converter rear panel
WARNING!
Remember to follow basic safety rules on electronic device
handling while opening the converter:
✔
Keep your hands dry,
✔
If floor is carpeted ground spray surroundings with
water mist and ground your wrist to the chassis before
unpacking and handling the DIO card.
✔
Turn off power and detach power and signal cables
while working with the top cover removed.
Before installing the
card, check if the
converter’s firmware
supports DIO-FW
card (version 4.5.3 or
later). If not, contact
Mytek and request
current version.
Page: 6 / 25