Introduction, Before you begin – Mytek Digital FW DIO Card (ver. 1.2 / Nov 2010) User Manual
Page 4
Mytek FW DIO Card – User Manual
Introduction
The Mytek FW DIO Card is an optional card that is installed
into the rear expansion slots of the Mytek 8X192 ADDA
converter. With this card installed the Mytek 8X192 ADDA can
be directly connected to a MAC OS or Windows computer via
FireWire. The card may be installed by the user as described
further in the manual.
Before You Begin
Before connecting the DIO-FW card please check if the most
current firmware (version 4.5.3 or later) is installed in the
8X192 converter. To verify the version, locate the firmware chip
(8 pin DIP chip in a socket near the aluminum heat sink) on the
main converter board or contact Mytek should you require
assistance.
In the support section of the Mytek website at:
you will find current detailed information about firmware
versions and most current firmware and driver update
instructions. (If necessary contact Mytek and request that
appropriate firmware be sent to you.)
Page: 4 / 25