Mainboard firmware update – Mytek Digital FW DIO Card (ver. 1.2 / Nov 2010) User Manual
Page 21
Mytek FW DIO Card – User Manual
Mainboard firmware update
This update might be necessary to bring the converter's main
board up to date to allow its operation with the firewire card.
Generally installed main board firmware should be of rev. 4.5.3
or greater. Contact Mytek via email to obtain current firmware
chip.
WARNING!
Remember to follow basic safety rules about handling of
electronic device while opening the converter:
✔
keep your hands dry,
✔
remember to turn off power and disconnect power
and signal cables while working with the top cover
removed.
To perform firmware update of 8X192 ADDA converter:
1. Check if the power cord and signal and clock lines are
disconnected.
2. Remove the top cover.
Page: 21 / 25