Mytek Digital FW DIO Card (ver. 1.2 / Nov 2010) User Manual
Page 24
Mytek FW DIO Card – User Manual
7. Attach power cord and other cabling.
8. Turn on the converter.
For about 2 seconds no LED should be lit on the converter’s
front panel, as new software is copied from memory to the
main board chips. Then, all LEDs should turn on momentarily
for about 10-20sec, and subsequently the unit should begin
normal operation.
Check Mytek webpage for information on the latest firmware
versions.
www.mytekdigital.com
Page: 24 / 25