Muchmore Motor Master (PT-CTXM3) - Manual (Page 17)

8.ERROR MESSAGES
Hook up Motor!
Amps too high!
Temps too hot!
Supply is poor!
Input volt high!
Check aligator clips, brushes,
brush springs.
Your motor consumes over 25A!
"Set Motor Spd UP: 1" at Setup menu.
Motor master is too hot to operate!
Cool down it, then operate.
Use power supply that has higher
capacity(more than 20A).
Decrease output voltage of power supply
down to 17.0V.
Motor master's FET is dead,
pls send us for repair.
Adjust output voltage of power supply
at 10.5~17.0V.
Out of order
Call for service
INPUT VOLT ERROR
VOLT : 10.04
Power supply tip
Motor master V3.2 Platinum, Marc Rheinard, Andy Moore Editions and
Surikarn V3.0 allow 10.5~17.0V input voltage.
If you set your output voltage of power supply as high as possible,
CTX-M will consume less capacity.
For example, If you set your supply output volt
at 16.9V, you can run even 7 turn motor(cunsuming 19ampere)
with 10ampere power supply!
7.Setup menu
S e t U p M e n u V 3 . 2
Motor Spd UP : 1
S e t U p M e n u V 3 . 2
Hook-up: OFF
Setup menu change
Press & hold : exit setup menu,
Backward
Value change, Increment, Decrement
On/Off
Forward
A. Key operations
B. Key operations
Adjust the speed of motor starting speed.
5 is the fastest acceleration mode.
If you use less than 14 Amp 12V power
supply, set this value at 1(slow start).
This mode is for severe motor tuner who
must tune tons of motor!
If you select OFF, CTX-M will not make
"Hook up motor!" error messege.
You don't have to push enter button
every time. Just connect or disconnect
alligator clips!
S e t U p M e n u V 3 . 2
Sound Lev. : 1
You can select button sound 0~10.
0 is off, 1~5 are single sound, 6~9 are
double sound.
S e t U p M e n u V 3 . 2
M-RUN SAVE : ON
If you choose ON, you can
save Data after every 1.Motor Run.
S e t U p M e n u V 3 . 2
CTX-T SAVE : ON
If you choose ON, you can save Data
after every 2.CTX-Test.
E7