Muchmore Motor Master (PT-CTXM3) - Manual (Page 14)

3.Break In
Return to main menu, backward
Increment or Decrement
of values.
Motor start or stop, forward
L : 1 . 0 H : 3 . 0 P L : 1
T: 1 m D : 1 m C : 1
Set low voltage.
Set high voltage value.
It must be 1V higher
than the low for Pulse break in.
Set the Running time(minutes)
1~99min.
Set the Running time(minutes)
1~99min.
Set the Delay time(minutes) 1~99min.
Set the Delay time(minutes) 1~99min.
Set the Cycle time
1~99times
Set the Cycle time
1~99times
Choose Pulse speed 1~5.
5 is the fastest
up and down mode.
L : 3 . 0 H : 3 . 0 P L :
T: 1 m D : 1 m
*
C : 1
Set Low voltage
Set this value equal
to lower voltage.
A. Key operations
B. Standard break in
C. Pulse break in
This mode runs motor at linear voltage.
This mode runs motor as pulse. You can set low and high voltage and pulse speed.
D. Break in example
3. 01 4. 25 17100
T: 2 D: 1
Cycle: 2
0. 00 0. 00 0
D:00:58 Cycle: 2
0. 00 4. 04 0
End Break In
L: 3.0 H: 4.0 P: 1
T: 01: 52
3. 01 4. 25 17100
Cycle: 1 T: 01: 52
C: 2
Remaining cycle times.
Delay time
If you set values as below,
motor will run 3.0~4.0V with pulse speed 1.
2minutes runs-1minute delay-2minutes run then finish.
Remaining cycle times.
Running time
Running time
If you set low & high
voltages equal, this mark
will appear. Voltage can
be changed during
standard break in.
E4