2 ethtool command syntax, 3 mii-tool command syntax, Ethtool command syntax – Maxim Integrated 78Q8430 Linux Driver ARM Platform User Manual
Page 16: Mii-tool command syntax
78Q8430 Linux Driver ARM Platform User Guide
UG_8430_008
16
Rev.
1.0
2.2 ethtool Command Syntax
The following syntax summary lists the ethtool version 4 command options supported by the 78Q8430
device driver. ethtool can be obtained from:
The EEPROM modification command described below requires a code conveyed by the 'magic' operand.
The required code is 8430.
~# ethtool -h
Displays command syntax (as shown below).
ethtool version 4
Usage:
ethtool DEVNAME
Display standard information about device.
ethtool -i|--driver DEVNAME
Show driver information.
ethtool -e|--eeprom-dump DEVNAME Do an EEPROM dump.
[ offset N ]
[ length N ]
ethtool -E|--change-eeprom DEVNAME Change bytes in device EEPROM.
[ magic 8430]
[ offset N ]
[ value N ]
2.3 mii-tool Command Syntax
The following syntax summary lists the mii-tool version 4 command options supported by the 78Q8430
device driver. mii-tool can be obtain
~# mii-tool
Usage: mii-tool [-VvRrwl] [-A media,... | -F media] [interface ...]
-R, --reset
Reset MII to power on state.
-F, --force=media
Force specified media technology.
media: 100baseT4, 100baseTx-FD, 100baseTx-HD,
10baseT-FD,
10baseT-HD,
(to advertise both HD and FD) 100baseTx, 10baseT