Make Noise RxMx - Manual (Page 11)

PaTCH Id EAs
Cadavre Exquis
-Patch any six audio sources to the six inputs of the RxMx. Set Level full CW, Radiate full CCW, Channel Full
CCW.
-Patch Wogglebug Stepped Random to Channel CV Input 1, adjusting input attenuator to allow random selection
of all six channels. Adjust Wogglebug clock to taste.
Mélangeur Automatique
-Same patch as "Cadavre Exquis", but use a non-random stepped voltage source such as René or BRAINS/
Pressure Points.
Taxonomy
-Mult a single audio source to channels 1, 3 and 5. Optionally, mult a second source to 2, 4, and 6.
-Patch A, B, and C Outputs to three audio-processing destinations of your choice: ring mod, echo, reverb etc.
-Apply control voltage to Channel CV input to switch rhythmically between different effects processes.
-Increase Radiate to engage multiple effects at once in parallel.
Panopticon
-Patch six sources of your choice to the RxMx signal inputs.
-Engage cycling on Function, and patch Function + Output to Channel CV Input 1.
-Patch Pressure Points Common Gate or BRAINS T-Gate to HANG input on Function, Common Pressure Out
to Radiate CV Input.
Press a touchplate to focus on a single channel and increase width of vision by pressing harder on the touchplate.
Don’t let anything escape you.
Encounters
-Clock Wogglebug, BRAINS and René with a single clock, or with different clocks.
-Patch the three Pressure Points Tuned Voltage outputs to Ch 1-3 of RxMx
-René QCV and CV to Ch4 and Ch5 (for best results use a saved location on the Q page to allow the two
outputs to be independent)
-Patch Wogglebug Stepped Random Output to Ch6.
-Patch RxMx B Output to 1v/Oct Input on a VCO such as the STO.
-Mult various versions of the same sequence outputs to Level, Radiate and Channel CV Inputs, or manipulate
the Panel Controls manually to mix, match and paint sequences.