Make Noise Powered-Busboard / Mini-PWR - Manual

15-18 Vdc
+ -
374mm
101.5mm
4.5
4.0
49.5
52.0
37.0
50.0 (Typ) 37.0
3.2
93.5
Powered Bus Board (PBB)
* PBB works anywhere in the world, and at 85% efficiency is greener than most linear power supplies.
* The PBB sources up to 1.4 amps at 12Vdc, 1A @ -12Vdc, and 250 mA at +5Vdc. (supply will operate at
capacity greater then spec, but with poorer stability)
* If desired, an upgrade is available to 1.4A @ 5Vdc.
* 20 eurorack standard power connectors.
* Automatic shut-off when current draw exceeds 3A.
* Fits in 90HP-104HP case, with a maximum of two rows of modules per bus board.
* Board is to be mounted ‘upside down’ with electronics facing bottom of enclosure, 11mm
minimum clearance required.
* Power input should be 15-18Vdc @ 4A, please select connectors and wire accordingly.
* Recommended AC Adapter: Volgen KTPS65-1543DT 3P, available from Digikey and Make Noise.
* To ease installation, connect barrel jack to 15-18 Vdc Inlet on PBB BEFORE final installation.
(Mate DC Inlet with Molex 19018-0014 connectors or similar)
* Blade connectors in grey below are not populated, but can be used to share output power and
bus CV or gate signals wherever desired.
* Installation video at http://youtu.be/aRd6I6p6Jjw -- or search ‘powered bus kit installation.’
* Questions answered at [email protected]
Mini Powered Bus Board
* Also mounts ‘upside down,’ requiring 11mm of clearance.
* Sources 1A @ +12Vdc, 500mA @ -12Vdc, and 200mA @ +5Vdc to two eurorack-standard connectors.
* Requires 15Vdc power supply sourcing 2A per bus board, works anywhere in the world!
* Recommended AC Adapter: Volgen KTPS65-1543DT 3P, available from Digikey and Make Noise.
* Automatically shuts off when current draw exceeds 1.5A total.
* Lightweight and low profile.
15Vdc
+ -