LR Baggs RT System - Manual (Page 2)

I N S T A L L A T I O N ( c o n t i n u e d )
pickup wire to the underside of the guitar top with one of the platforms. Note: This is not referring to the peel-and-stick
foam on the pickup itself. Choose a location for the platform between the pickup and preamp, several inches away from the
pickup. If there is a brace that the wire will cross, make a little slack in the wire so it does not touch the brace.
G A I N C O N T R O L S E T T I N G S
U S E R ' S G U I D E
The RT System preamp by itself has no user controls. The output level has been set to the -10dB standard when partnered
with the Ribbon Transducer. The RT System preamp is designed to interface with just about anything you can plug into. The
output jack acts as the switch - plug it in and it's on, unplug it and it's off. The easiest way to check the battery is to plug
into your rig and play very hard on the lower strings. If you hear a fuzztone, drop in a fresh battery.
The RT Remote Control gives you volume and tone controls as well as a battery status LED that fades as the battery
weakens. We recommend that you use a high quality PA or acoustic guitar amp to realize the best performance from these
systems. Both should sound great with little or no EQ.
483 NORTH FRONTAGE RD., NIPOMO, CA 93444
PHONE (805) 929-3545 - FAX (805) 929-2043 - WWW.LRBAGGS.COM