Lippert Components 3 X 3 Slideout System - Manual (Page 4)

Disassembly of the motor voids the warranty.
Mechanical portions of the slideout system are replaceable. Contact
Lippert Components, Inc. to obtain replacement parts.
PIVOT RAIL– see Fig. 1 page 5
The Lippert 3 x 3 Slideout System has three basic assemblies:
1. Outer Rail –Flange welds to frame of coach. Flange is
mounted to the outside end of the outer rail. The inside end of
the outer rail is welded to frame also.
2. Inner Rail - Inner Rail rides inside outer rail and is actuated by
the rack gear welded to the bottom of the rail and the pinion
gear in the Gear Drive Assembly. Mounting Plate on the
outside end of the inner rail is bolted to the slideout room and is
slotted for room adjustment.
3. Gear Drive – Houses drive shaft and pinion gear. 12V DC
motor attaches to drive shaft to actuate system.
PRIOR TO OPERATION
Prior to operating the Lippert 3 x 3 Slideout System, follow these four (4)
guidelines:
1. Coach should be parked on the most level surface available.
2. The PARKING BRAKE must be engaged.
3. The coach’s transmission must be in NEUTRAL or PARK.
4. The coach’s ignition must be in the RUN position or the coach’s
engine must be running.
4