Canon PSC 2000 - Manual (Page 11)

2000 Fire Door-Fan Manual updated 2002-05-28
Page 11 of 58
Take the 7ft red tube and throw outside, away from
the air blast of the door fan and if outdoors, away
from wind if possible. If you were testing from
outside the room, this tube would then get thrown
inside.
Insert the motor control connector into the
receptacle till it clicks.
E and J models will not have a control connector
since the knob on the blower is used.
Plug the clear flow pressure pick-up tube into the
nylon quick-connect on top of the blower. Gently
push while giving it a quarter turn.
Make sure the 7ft red cord and thermometer are in
the corner to the panel and the thermometer is on
the backside of the panel. Plug power cord from
Blower to wall outlet.