KERN & SOHN VHS 2T1 - Manual (Page 12)

¾
Press
PRE-
TARE button
¾
Press the numeric TOTAL up or down
PRE-
TARE key until the flashing number has reached
the desired value.
¾
To move to the next segment, press the key TARE
¾
Repeat this action until the display shows the desired tare value.
¾
To activate the tare weight (but not for storing): Press the TARE key for three
seconds, to confirm the value.
‰
The tare weight is now activated.
‰
“NET” appears.
‰
If the system is loaded at this moment, the net value of the weighed weight
appears on the display.
‰
If the system is unloaded, the system indicates the entered tare value negative.
‰
The entered value remains active until the weighing system is turned off, a new
tare weight entered, a new load tared (See 7.3.) or if a reset to zero is carried
out:
¾
The weighing system is loaded: Press the
PRE-
TARE key for two seconds. The tare
value will be reset to zero and the system reverts to standard weighing mode.
or
¾
The weighing system is unloaded: Press TARE button A reset to zero is
carried out and the system reverts to standard weighing mode.
¾
To activate and store the tare weight: Confirm all segments by pressing the TARE
key.
‰
The tare weight is now activated and stored.
‰
“NET” appears.
‰
If the system is loaded at this moment, the net value of the weighed weight
appears on the display.
‰
If the system is unloaded, the entered tare value is shown negative.
‰
The entered value remains active even after the system was turned off, until a
new tare weight is entered, a new load tared (See 7.3.) or a reset to zero is
carried out.
¾
The weighing system is loaded: Press the
PRE-
TARE key for two seconds. The tare
value will be reset to zero and the system reverts to standard weighing mode.
or
¾
The weighing system is unloaded: Press button. A reset to zero is carried
out and the system reverts to standard weighing mode.
VHB/VHS-BA-e-1012 12