KERN & SOHN BAN 3T-3M - Manual (Page 3)

1 General
These installation instructions contain all data necessary for placing and
commissioning the weighing bridge KERN KFP 1500V40M.
2 Technical data
Model Weighing
range
Max Readabil
ity d Verificati
on value
e Minimum
load
Min Preload
additive Cable
length
approx. Net
weight
approx.
kg g g kg kg m kg
KFP 1500V40M 1500 500 500 10 250 3 175
3 Basic instructions
3.1 Documentation
These installation instruction contain all data necessary for placing and
commissioning the weighing bridges KERN KFP V
40.
In combination with a display unit, described below as weighing system, for operation
configuration, please refer to the operating instructions of the display unit.
3.2 Proper use
The balance you purchased is intended to determine the weighing value of material
to be weighed. It is intended to be used as a “non-automatic balance”, i.e. the
material to be weighed is manually and carefully placed in the centre of the weighing
plate.. As soon as a stable weighing value is reached the weighing value can be
read.
3.3 Improper Use
Do not leave permanent load on the weighing bridge. This may damage the
measuring system.
Impacts and overloading exceeding the stated maximum load (max) of the weighing
system, minus a possibly existing tare load, must be strictly avoided. The weighing
system could be damaged.
Never operate in an explosive environment. The serial version is not explosion
protected.
Changes to the weighing system's design are not permitted. This may lead to
incorrect weighing results, safety-related faults and destruction of the balance.
The weighing system unit may only be operated in accordance with the described
default settings. Other areas of use must be released by KERN in writing.
3 KFP V40-IA-e-1110