Kenton Plugstation ver.2.01 - Manual (Page 88)

KENTON PLUGSTATION USERS MANUAL
88
P-ID – Selects the PLG ID number for cards (should only be used if multiple cards of the same type
are used)
CCNO – Selects the controller number being edited for each PLG card
CVAL – Sets the amount of the previously selected controller number
GLOBAL LEVEL
SVOL – Sets the Global SW1000XG return volume for all 4 cards
D-NO – Sets the Global Plugstation device number
MCH- Sets the Global Midi channel for control of Plugstation
SHLD – Sets the SW1000XG wordclock detection “Hold” mechanism on startup
YOPL LEVEL
OUT 1-8 – Sets the Y OUTPUT level Gain control and trim control for each output
ZSOP LEVEL
SVOL – Sets the SW1000XG output through the Z-BOARD level (to Y-BOARD output)
SBAL- Sets the SW1000XG output through the Z-BOARD level (to Y-BOARD output)
SOPS – Sets the SW1000XG output select for the main Serial output feed through the Z-Board to the
Y-BOARD outputs
MUT – Stops all SW1000XG audio and MIDI synth parts being sent to the Y-OUTPUTS, but allows
them still to be sent to a DS2416 SUB input set if connected
PRGS LEVEL
LOAD – Loads a Global setting (P-XX allows you to load up individual performances in the STATUS
LEVEL)
STORE – Allows you to store Performances or Global setups
DUNP – Bulk Dump menu option fotr backup of performance and Global data
MAP – Allows you to remap an incoming performance dump to a new performance location