K-Edge K13-602 - Manual (Page 2)

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!
Page 2 of 7
Warnings:
All K-EDGE products are to be installed by a professional bike mechanic.
These instructions are generalized to accommodate a wide ranges of setups for a bike. If your setup
does not match what is being described, take extra care in the process of your setup and contact K-
EDGE Support if you have any questions pertaining to this installation.
Improper installation of any K-EDGE product or use outside of its design intentions could lead not only to
damaging the bike but could also cause per
s onal injury to the rider.
Parts Included:
K13-602:
1x K-EDGE SRM Pro Chain Catcher
1x M5 x 20mm stainless steel cone head SHCS (For Campagnolo (except EPS) and SRAM)
1x M5 x 17mm stainless steel cone head SHCS for (For Shimano)
1x M4 x 9.5mm stainless steel cone head SHCS with thread-lock pre-applied
1x Pro Radius washer
2x M3 x 5mm stainless steel BHCS with thread-lock pre-applied
1x M3 x 5mm stainless steel FHCS with RED thread-lock pre-applied
1x Neodymium Magnet with countersunk hole
1x K-EDGE Magnet Arm
Important Notes:
! The 2x M3 x 5mm BHCS holding the Magnet Arm DO NOT COME PRE-TORQUED, this will be done on
Step #8 of the installation process.
! Periodically check the integrity of the cadence magnet, replace if cracked or chipped.
Tools/Items Required:
Metric Allen Set (2mm, 3mm, and 4mm for mounting/locking bolts)
Torque wrench