Zoom H4n - Manual (Page 141)

Ef
fect types on MTR mode and the parameter
140
SVT Simulation of Ampeg SVT sound.
BASSMAN Simulation of Fender Bassman 100 sound.
HARTKE Simulation of Hartke HA3500 sound.
SUP-Bass Simulation of Marshall Super Bass sound.
SANSAMP Simulation of Sansamp Bass Driver DI sound.
TUBE PRE ZOOM original tube preamplifier sound.
● Bass preamp effect types
(1) CABINET 0 − 2 Adjusts the intensity of the speaker cabinet sound.
(2) GAIN 0 − 100 Adjusts the preamp gain (distortion depth).
(3) BASS -12 _ 12 Adjusts boost/cut in the low range.
(4) MIDDLE −12 _ 12 Adjusts boost/cut in the middle range.
(5) TREBLE −12 _ 12 Adjusts boost/cut in the high range.
(6) BALANCE 0 − 100
Sets the mixing balance between the signal before
input and after passing the module. Higher values
result in a higher ratio of post-module signal.
(7) LEVEL 1 − 100
Adjusts the level of the signal after passing the
PREAMP module.
(8) ZNR
(ZOOM Noise Reduction)
OFF,
1 − 16
Adjusts the sensitivity of the noise reduction circuit
developed by ZOOM.
The above 6 effect types have the same parameters.
• Manufacturer names and product names mentioned in this table are trademarks or
registered trademarks of their respective owners. The names are used only to illustrate
sonic characteristics and do not indicate any affiliation with ZOOM CORPORATION.
VO MPRE Preamp with characteristics optimized for vocals.
AG MPRE
Preamp with characteristics optimized for recording an acoustic
guitar.
FlatMPRE Preamp with flat characteristics.
● Mic preamp effect types
(1) COMP
OFF,
1 − 10
Adjusts the parameter which keeps the level within
a certain range by attenuating high-level signals
and boosting low-level signals.
(2) DE-ESSER
OFF,
1 − 10
Adjusts the degree by which sibilants are attenu-
ated.
(3) LOW CUT
OFF,
1 − 10
Adjusts the frequency of a filter designed to at-
tenuate low-frequency noise that is easily picked
up my a mic.
(4) BASS -12 − 12 Adjusts boost/cut in the low range.
(5) MIDDLE -12 − 12 Adjusts boost/cut in the middle range.
(6) TREBLE -12 − 12 Adjusts boost/cut in the high range.
(7) LEVEL 1 − 100
Adjusts the level of the signal after passing the
PREAMP module.
(8) ZNR
(ZOOM Noise Reduction)
OFF,
1 − 16
Adjusts the sensitivity of the noise reduction circuit
developed by ZOOM.
The above 3 effect types have the same parameters.