Chrysler 2007 Sebring Sedan - Manual (Page 210)

To exit the Remote Start mode , allow the
engine to run the cycle or depress the unlock
button to disarm the Vehicle Theft Security
Alarm and within one minute insert the key
into the ignition and turn the ignition to the RUN
position. The ignition must be in the RUN position in
order to drive the vehicle.
NOTE: The engine can be started two consecutive times
(two 15 minute cycles) by using the key fob. For a third
cycle, the key must be cycled to the ignition RUN
position and then repeat the start sequence.
To shut off the vehicle when it is in Remote Start mode,
press the remote start button once. In order to avoid
inadvertent shut downs, the one-time press to shut down
the vehicle will be disabled for two seconds after receipt
of a valid remote start request.
NOTE: When the vehicle is in the Remote Start mode,
power window and sunroof operation are disabled for
security.
The following conditions must be met before the engine
will remote start:
• Automatic Transaxle in Park
• All doors are closed
• Hood is closed
• Hazard Switch is off
• Brake Switch is inactive
• Key is not in the ignition
• Battery is at an acceptable charge level
• Panic button on key fob is not depressed
REMOTE START BUTTON
210 STARTING AND OPERATING