Chrysler 2007 Sebring Sedan User Manual

Page 116

in the hand-held transmitter of the device being pro-
grammed. This will allow for quicker training and accu-
rate transmission of the radio-frequency signal.

If your garage door opener (located in the garage) is
equipped with an antenna, make sure that the antenna is
hanging straight down.

1. Erase the factory test codes by pressing the two
outside buttons. Release the buttons when the light in the
Universal Transceiver begins to flash (about 20 seconds).

NOTE:

Step 1 above does not have to be followed to

program additional hand held transmitters.

2. Choose one of the three Universal Transceiver buttons
to program. Position the end of your hand-held transmit-
ter 1-3 inches (3-8 cm) away from the HomeLink buttons
while keeping its indicator light in view.

3. Simultaneously press and hold the HomeLink button
(that you want to train) and the hand-held transmitter
button. Do not release the buttons until Step 4 is
complete.

NOTE:

Some gate operators and garage door openers

may require you to replace this Programming Step 3 with
procedures noted under

ЉGate Operator/Canadian Pro-

gramming.

Proper Transceiver Training Distance

116

UNDERSTANDING THE FEATURES OF YOUR VEHICLE