Concord Camera Concord Eye-Q 4363z - Manual (Page 46)

44
En
RESTORE THE CAMERA TO FACTORY DEFAULT SETTINGS
To restore the default settings in your camera:
1. Press when Restore Default is highlighted in the camera.
2. Press or to highlight No or Yes, and then press OK.
• When No is selected, no change is made. The LCD returns to the previous screen.
• When Yes is selected, the LCD shows “Are you sure?”
3. Press or to highlight Yes or No, and then press OK.
• If No is selected, no change will be made. The LCD returns Setup page.
• If Yes is selected, the camera will be reset to the factory default setting. The LCD will show “Restoring...”
for a few seconds and then return to setup page. The Default settings will be restored.
Note: Please refer to the table below for the default settings.
OPTION DEFAULT STATUS
Camera Mode Single Shot
Image Size 2272 x 1704
Quality Normal
Flash Auto Flash
White Balance Auto
LCD Brightness Center (0)
Scene Selection OFF
Digital Zoom Yes
Exposure Compensation 0
ISO Auto
Metering Matrix
Photo Effect None
Time Out 2 min
Slide show interval 2 Seconds
Beep ON
Quick View 1 Sec
AF Mode Multi-Area
Continuous Repeat No
AF Assist Light Auto
TV Mode NTSC for USA/Japan, PAL for Europe/Asia
Date/Time Format USA/Japan: MM/DD/YYYY, 12-hour
Europe/Asia: DD/MM/YYYY, 24-hour
RESTORE THE CAMERA TO FACTORY DEFAULT SETTINGS
DZ4363 UG(514338-02)-E 44 6/16/04, 10:20:51 AM