Citizen Systems iDP-562 - Manual (Page 29)

iDP-562 User’s Manual
CITIZEN 24
4 Graphic Print Mode Designation
ESC(1B) K(4B) n
1
n
2
DATA
Input ESC K (1B 4B) at the top of the line and then input Graphic Print Data, which is converted to binary, into
n
1
. After that, input dummy data in n
2
.
If it is also the Graphic Print in the next line, ESC K n
1
n
2
should be input once again before the data.
The number for Graphic Print Data should be:
1
≤
n1
≤
240
Any numbers other than the above comes to 240.
5 Graphic Print Data
Printing in seven lengthwise dots by 240 rows can be made in one line. The 7 lengthwise dots are input as the
graphic print data. The data are computed as follows:
→
The position as traced from the home position
Correspondence of headpin to graphic print data
As will be understood from the above, the data are used in which the first dot corresponds to the first bit and
the 7th dot corresponds to the 7th bit. The 8th bit is disregarded. Try to select decimal data or hexadecimal data
matching to the host computer.