Citizen Systems iDP-562 - Manual (Page 28)

iDP-562 User’s Manual
CITIZEN 23
7.3 Input Data Format
The input data to the printer is made by the codes listed in the Character Code Table.
1 Standard Character print Mode Designation
US(1F) DATA
Designation of standard character print mode is made immediately after power-on and initialization or after print.
Therefore US code can be omitted. In addition, when the data of 40 characters (standard character mode) is input
in one line, an automatic line feed is carried out after printing (full buffer print). For 8 BIT DATA SI code is the
same as US code.
2 Enhanced Character Print Mode Designation
RS(1E) DATA CR(0D)
All the print data which follow RS code are enhanced and are reversed to standard character by US code.
You can print the both standard and enhanced characters in one line. Automatic printing is carried out when full
column data (40 columns in standard character) is input.
This RS code is released automatically after printing. For 8 BIT DATA SO code is the same as RS code.
3 Red Print Mode Designation
DC(12) DATA CR(0D)
Red Print Mode is designated by DC2 code and released after printing one line. It is not possible to print Red and
Black printing in one line. If DC2 code is input again in the same line, Red Print Mode is released and the entire
printing in the line is printed in Black.