Citizen Systems iDP-562 - Manual (Page 14)

iDP-562 User’s Manual
CITIZEN 9
5.2 Setting of DIP Switch and SLIDE Switch
Following function are available by setting DIP switch and SLIDE Switch.
Selection of “CR” and “LF” code function.
Please refer to the table below.
DSW-1 DSW-2 DSW-3
CR and LF code When CR code comes
are valid function. immediately after full When the buffer is blank.
*OFF buffer printing
*OFF CR code is void *OFF CR code is valid
CR code is selected by
the DSW-2 and 3.
ON CR code is valid ON CR code is void
CR code is ignored When LF code comes
When the buffer is blank.
ON
immediately after full buffer
printing
*OFF LF code is void *OFF LF code is valid
LF code is valid.
LF code is selected by
the DSW-2 and 3.
ON LF code is valid ON LF code is void
It is recommended to set the DIP switches in accordance with your host’s output DATA format.
DATA Form DSW-1 DSW-2 DSW-3
DATA + CR OFF OFF OFF
DATA + LF
DATA + CR + LF
ON OFF OFF
DATA + LF + CR
Foreign character USA GERMANY FRANCE UK
Selection DSW-4 *OFF OFF ON ON
DSW-5 *OFF ON OFF ON
ODD EVEN No Check
Parity check DSW-6 *OFF ON *OFF ON
DSW-7 OFF OFF *ON *ON
Selection of DATA DSW-8 ON 7 bit DATA
bit length *OFF 8 bit DATA
SSW *OFF 9600 4800 2400 1200
Selection of Baud Rate -1 ON 1200 600 300 150
DSW-9 *OFF OFF ON ON
DSW-10 *OFF ON OFF ON
NOTE: * Marks are a “Factory Setting”.